Lead holder and ground test accessories

Lead holder : coil rest for large length leads, ideal for "field" use because of its design and sturdiness.

Small lead holder for lead length up to 20 m (7 ft).
P / N 2222.

Example of a lead wound around a small lead holder

Big lead holder for lead length up to 50 m (17 ft).
P / N 2222-50.

Example of a lead wound around a big lead holder

EARTH rod : earth rod to plunge into the ground. Earth test accessory.

Specifications :

length 23.5 cm (9.3 in)
diameter 8 mm (0.3 in)
steel material
handle on one end and tip on the other end

P / N 2221.

Earth set : set of accessories to complete earth measurements on the ground.

This kit P / N KIT/TEST-EARTH includes :

4 EARTH rods (P / N 2221 above) in steel material, 23.5 cm (9.3 in) length, to plunge into the ground
1 alligator clips / female Ø4 mm connector lead, 5 m (16.4 ft) length, green, on lead holder (P / N 2222 above)
1 alligator clips / female Ø4 mm connector lead, 5 m (16.4 ft) length, black, on lead holder (P / N 2222 above)
1 alligator clips / female Ø4 mm connector lead, 20 m (65.6 ft) length, bleu, on lead holder (P / N 2222/20 above)
1 alligator clips / female Ø4 mm connector lead, 20 m (65.6 ft) length, red, on lead holder (P / N 2222/20 above)

Electrical specifications of the leads :

maxi. voltage 1000 V, measurement category III (CAT III)
maxi. current 12 A
reinforced insulation ( )
pollution degree 2
compliant with IEC 61010-031 international standard and Low Voltage Directive (LVD) (93 / 68 / EEC and 73 / 23 / EEC)
0.75 mm² PVC cable

Other earth accessories ...

Definitions (according to IEC 61010-031 standard, "Safety requirements for electrical equipment for measurement, control and laboratory use - Part 031 Safety requirements for hand-held probe assemblies for electrical measurement and test") :

CAT III (measurement category III) : measurements performed in the building installation. Examples are measurements on distribution boards, circuit-breakers, wiring, including cables, bus-bars, junction boxes, switches, socket-outlets in the fixed installation, and equipment for industrial use and some other equipment, for example, stationary motors with permanent connection to the fixed installation.

Reinforced insulation and double insulation ( ) : protection insulation equal to 2 basic insulation at least. Required for any hand-held accessory.

Pollution : addition of foreign matter, solid, liquid or gaseous (ionized gazes), that may produce a reduction of dielectric strength or surface resistivity.

Pollution degree 2 : normally only non-conductive pollution occurs. Occasionally, however, a temporary conductivity caused by condensation must be expected.

Contact :

Address : Electro PJP   31 rue Julien Feuvrier   BP366   F-39105 Dole   France
Phone : (33) Ø3 84 82 13 30,   Fax : (33) Ø3 84 82 40 48
E-mail : mail@electro-pjp.com,   Web : http://www.electro-pjp.com