Ø4 mm connectable test tip / Ø4 mm male connector adapter.
|
![]() |
| Adapter without its sleeve. P / N 2310/404-Sp. | Adapter with its sleeve, and inner sight of the Ø4 mm insulated male connector (red tip). P / N 2310/404-Sp. |
Application : connecting the male connector of the adapter on a Ø4 mm female socket, this one becomes a Ø4 mm connectable tip.
| Exemple : | |
![]() |
![]() |
| Sight of a Ø4 mm female socket set on a panel (for example, socket of a test device). It is impossible to make contact between a component and the socket. | Thanks to the adapter connected to the socket, now it is possible to make contact between component and socket. |
Specifications :
Definitions (according to IEC 61010-031 standard, "Safety requirements for electrical equipment for measurement, control and laboratory use - Part 031 Safety requirements for hand-held probe assemblies for electrical measurement and test") : CAT III (measurement category III) : measurements performed in the building installation. Examples are measurements on distribution boards, circuit-breakers, wiring, including cables, bus-bars, junction boxes, switches, socket-outlets in the fixed installation, and equipment for industrial use and some other equipment, for example, stationary motors with permanent connection to the fixed installation. Reinforced insulation and double
insulation ( Pollution : addition of foreign matter, solid, liquid or gaseous (ionized gazes), that may produce a reduction of dielectric strength or surface resistivity. Pollution degree 2 : normally only non-conductive pollution occurs. Occasionally, however, a temporary conductivity caused by condensation must be expected. |
| Contact : | Address : Electro PJP 31 rue Julien
Feuvrier BP366 F-39105 Dole France Phone : (33) Ø3 84 82 13 30, Fax : (33) Ø3 84 82 40 48 E-mail : mail@electro-pjp.com, Web : http://www.electro-pjp.com |